The solution to the pneumatic cylinder gas is as follows:
1. Clean the piston rod and seal ring, if dirt or impurities are stuck in the seal, it may cause the cylinder to gas.
2. Check the surface quality of the guide sleeve. If there is any problem, replace the guide sleeve with a new one.
3. If the above two points are not a problem, then you may need to adjust the air pressure or nut pressure. This usually requires experimentation in the workshop in order to determine the best setup. In general, it is safe to tighten a little, but do not over-tighten. This can damage the seal and may cause new problems.
4. Automatic locking “O” rings, metal dust caps, or other similar materials can be used to reduce the entry of dust and other particles, thereby reducing the probability of venting. In addition, regular maintenance is also important, including checking and maintaining all gaskets and dust covers.
5. Use high-quality pneumatic tools and equipment that have been well tested and proven for quality to maximize safety and avoid failures.
6. After handling the cylinder, remember to completely release the air to eliminate any residual pressure. This prevents the rod from moving too far and causing other problems.
7. For more serious cases, you need to return to the original manufacturer to repair or replace parts, you can also seek the help of professional maintenance personnel.
I hope the above method can help solve the problem. If you are not familiar with the operation, it is recommended to consult the relevant professional.
Tex/Fax: 0086-577-62840011
WhatsApp: 0086-13355775769
#Aircylinder#Pneumaticcylinder#SCcylinder#MAcylinder#Cylinderleakage
