2, installation form
Depends on the installation location, use purpose and other factors. In general, fixed cylinders are used. When it is necessary to rotate continuously with the working mechanism (such as lathes, grinders, etc.), it should be selected
Rotary cylinder. When the piston rod is required to swing in an arc in addition to the linear movement, the shaft pin type cylinder is selected. When there are special requirements, the corresponding special cylinder should be selected.
3, the size of the force
That is, the choice of cylinder diameter. According to the size of the load force to determine the cylinder output thrust and pull. Generally, the cylinder force required under the external load theoretical equilibrium condition is selected according to different speeds
With the same load rate, the cylinder output force is slightly surplus. The cylinder diameter is too small, the output force is not enough, but the cylinder diameter is too large, which makes the equipment bulky, the cost increases, and the gas consumption increases, and the energy is wasted. Under clamp
When designing, the force expansion mechanism should be used as far as possible to reduce the overall size of the cylinder.
Tex/Fax: 0086-577-62840011
WhatsApp: 0086-13355775769
#PneumaticCylinder #PneumaticAirCylinder #AirCylinder #CylinderPneumatic #pneumaticcomponent #pneumaticelement
