Supply room temperature resistant high temperature dust removal cylinder with limit switch cylinder SC100*300 with magnetic ring standard cylinder spot high temperature resistant cylinder suitable for all walks of life, for dust removal equipment on the cylinder generally supporting lifting valve and electromagnetic pulse valve use, Specific requirements and requirements of different cylinder diameter and stroke of the cylinder, cylinder flange, cylinder matching single ear and double ears, as well as cylinder standard gas rod and cylinder extension gas rod, etc.
The working principle of the cylinder lifting valve is that the compressed air enters the air source treatment element. After water filtration, decompression and lubricating oil treatment, the dry, clean and lubricated air with pressure enters the cylinder by the solenoid valve. The solenoid valve receives the signal of the electric control cabinet and controls the action of the cylinder to realize the automatic process of cold air, ash discharge, off-line ash removal, and return blower conversion. Standard cylinders can be divided into: 63, 80, 100, 125 specifications. Installation and use of SC Series 100 cylinder diameter dust removal cylinder:
1, work load changes, should choose the output force sufficient cylinder, under high temperature conditions, should choose the corresponding cylinder.
2. Before the cylinder piping, sundries in the pipe to prevent sundries from entering the cylinder.
3. The medium used by the cylinder should be filtered by more than 40m filter element before it can be used.
4, in the low temperature environment, anti-freezing measures should be taken to prevent the water in the system from freezing clean.
5, the cylinder should be used before the no-load test run, before the operation of the buffer to small, gradually enlarged, so as to avoid excessive impact and loss of cylinder.
6, the cylinder should avoid side load as far as possible in the working process, in order to maintain the normal working life of the cylinder, Fujian linear pulse dust collector lifting valve SC160X300 off-line valve cylinder bypass valve standard pneumatic components.
7. If the cylinder is removed and not used for a long time, it is necessary to pay attention to the surface rust prevention, and the inlet and exhaust port should be added with dust blocking cap.
Dust cylinder suitable for use in a variety of different industries, used in the dust removal device. Such cylinders are usually equipped with lifting valves and electromagnetic pulse valves. Generally speaking, different stroke of the cylinder, cylinder flange, cylinder configuration components of single ear double ear, as well as cylinder standard gas rod and cylinder lengthening gas rod, etc., professional manufacturers.
Tex/Fax: 0086-577-62840011
WhatsApp: 0086-13355775769
#cylinder #pneumatic#SCseriescylinder
